Nauticam NA-Shinobi-S housing for Atomos Shinobi 5.2 4K SDI

The Nauticam NA-Shinobi-S follows suit with the strong foundation Nauticam has built around previous Atomos monitor/recorder housings.  The NA-Shinobi-S supports the Shinobi SDI monitor.

The Shinobi is easily mounted in the housing, dropping in without trays or other mounting accessories and is held in place by two rotating locking levers. 

The NA-Shinobi supports up to the NP-F970 size battery which provides approximately 4 hours of run time. A CR-2032 battery powers the vacuum check and leak detection system. When used with the included Vacuum Valve, the system gives real-time feedback about the watertight integrity of the housing through an easily visible multi-color LED on the top of the housing.

Access to the touchscreen controls of the Shinobi are handled via a series of buttons and a selector knob beneath the screen of the housing.

 Surface Cable Diagram

Technical specifications:

What's In The Box:

• NA-Shinobi-S Housing
• 25096 SDI cable in 0.75m length (pre-installed)
• M25-M16 Step Down Adaptor (pre-installed)
• 25625 M16 Vacuum Valve II (pre-installed)
• Mounting ball (pre-installed)
• Monitor hood
• 25058 M16 SDI Bulkhead
• 25060 SDI cable in 0.3m length (for connection from camera to underside of SDI Bulkhead)
• 90137 Housing O-ring, lubricant, O-ring remover
• CR2032 Battery (for moisture alarm and vacuum system)
• Allen Wrench Set
• Padded Travel Case